Preparations
FM Antenna
For better FM stereo reception, connect an
outdoor FM antenna to the FM AERIAL (FM
ANTENNA) terminal.
C Speakers Connection
Front Speakers
Connect the speaker wires to the SPEAKERS
terminals, right speaker to "RIGHT" and left
speaker to "LEFT", coloured (marked) wire to
"+" and black (unmarked) wire to "-".
1
2
Fully inser t the stripped por tion of the speaker
wire into the terminal as shown.
Notes:
–For optimal sound performance , use the
supplied speakers .
– Do not connect more than one speaker to any
one pair of
+
/
-
speaker terminals .
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Optional connection
The optional equipment and connecting cords
are not supplied. Refer to the oper
ating
instructions of the connected equipment for
details.
Connecting other equipment to your
system
Connect the audio left and r
ight OUT terminals
of a TV, VCR, Laser Disc player, DVD player or
CD Re
corder to the
AUX I
N
term
inals.
Note:
– If you are connecting equipment with a mono
outpu
t (a single audio out te
rminal)
, connect it to
the AUX IN left terminal. Alternatively, you can use
a “single to double” cinch cable (the output sound
still remain mono).
Inserting batteries into the
remote contr
ol
Insert two batteries (not supplied) type R03 or
AAA into the remote control with the cor rect
polarity as indicated by the "+" and "-"
symbols inside the battery compar tment.
CAUTION!
– Remo ve batteries if they are exhausted
or will not be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances , so
they should be disposed off properly.
Preparations
AM
aerial
speakers
(right)
speakers
(left)
A
B
C
AC power cord
FM wire antenna
AM loop
antenna
Rear connections
The type plate is located at the rear of the
system.
A Power
Before connecting the AC power cord to the
wall outlet, ensure that all other connections
have been made.
WARNING!
–For optimal performance, use only the
original power cable.
–Never make or change any connections
with the power switched on.
To a void overheating of the system, a safety
circuit has been built in. Therefore, your
system may switch to Standby mode
automatically under extreme conditions. If
this happens, let the system cool down
before reusing it (not available for all versions).
B Antennas Connection
Connect the supplied AM loop antenna and FM
antenna to the respective ter minals. Adjust the
position of the antenna for optimal reception.
AM Antenna
Position the antenna as far as
possible from a TV,
VCR or other radiation source .
To Next Page
Loading...
