23
Optimize how the Media Center looks on your display
This option enables you to adjust display settings.
1 Select your display type.
2 Select the connection type of your display.
Note: If you are using the SCART output (21) of the Media Center, select Component (YpbPr).
3 Adjust display settings to your personal preferences in Display Calibration.
Note: If you select a wrong display setting the screen may turn black. Please wait for about 15 seconds, then the on-screen infor-
mation will be be visible again.
Setup your speakers
This option enables you to specify and test your speaker configuration.
• Always select the 2 speakers option since the Media Center offers analog stereo output only.
If you are using the digital audio connection:
After finishing the Media Center setup wizard, follow the instructions below:
1 Press the key (8) on the remote control.
> The Media Center Start menu appears.
2 Select More Programs and press the OK key (9)
3 Select DVD Settings and press the OK key (9)
4 Select Audio Settings and press the OK key (9)
5 Select SPDIF and press the OK key (9)
6 Select Save and press the OK key (9)
> After finishing the Optional Setup procedure, the Media Center’s Start screen is displayed and your Philips Media Center is
ready for use.
Note: S/PDIF (Sony/Philips Digital Interface) is a standard audio transfer file format, usually found on digital audio equipment or audio
processing devices. It allows the transfer of audio from one file to another without the conversion to and from an analog format,
which could degrade the signal quality.
To Next Page
Loading...
