1716
ENGLISH
◗ While rinsing shaver heads, water may drip
out of the base of shaver. This is a normal
occurrence.
1 Always turn shaver OFF, unplug from
outlet and remove power cord from
shaver.
C
2 Press the Release Button to open the
shaving unit.
C
3 Clean inside shaver heads and hair
chamber by running under hot water.
C
4 Clean outside of shaving unit by running
under hot water.
5 Close the shaving unit and shake off excess
water.
Be careful not to hit the shaving unit against
anything while shaking off excess water.
6 Open shaving unit again and leave open to
air dry.
NOTE: Do not wipe or dry the shaving heads
with a towel or tissue. This could damage the
shaving heads.
ENGLISH
◗ If you used foam or gel to shave, make sure to
rinse all of it off to prevent residue build-up
from clogging shaving heads.
◗ If the shaving unit becomes detached from the
shaver, you can easily reattach it.
Extra-thorough Cleaning Method
Do not mix up the cutters and combs as the
shaving performance may be adversely affected
for several weeks before optimal shaving
performance is restored.
1 Turn shaver OFF, remove the plug from the
outlet and power cord from the shaver.
C 2 Press the Shaving Unit Release Button to
open the Shaving Unit.
C 3 Pull the shaving unit off the shaver.
To Next Page
Loading...
