Trimming ear hair
Make sure your outer ear channels are clean and free from wax.
1 To switch on the appliance, turn the battery compartment cover
from the ‘off’ position (0) to the ‘on’ position (I).
2 Slowly move the trimming head along the rim of the ear to remove
hairs that stick out beyond the rim.
3 Insert the trimming head into the outer ear channel.
Do not insert the trimming head more than 0.5cm into your ear channel,
as this could damage the eardrum.
4 Slowly turn the trimming head around to remove all unwanted hairs
from your outer ear channel.
5 To switch off the appliance, turn the battery compartment cover to
the ‘off’ indication (0).
Trimming eyebrows with the eyebrow combs
1 Comb your eyebrows in the direction of hair growth.
2 Choose the short or long comb, depending on the desired hair
length.
- short comb: 3mm/0.12in
- long comb: 5mm/0.2in
Tip: We advise you to start trimming with the long comb. If you think your
eyebrows are still too long after this, use the short comb.
3 Slide the eyebrow comb onto the trimming head.
Make sure that the eyebrow comb has been properly slid into the
grooves on both sides.
ENGLISH 9
To Next Page
Loading...
