Philips P&S 22HFL4372D/10 - Page 36

Alignments
EN 36 Q552.1HE LA6.
2010-Nov-19
back to
div. table
Source selection EXT1/AV1 type SCART CVBS RGB LR Select input source when connected with external
equipment
CVBS Y/C YPbPr LR
CVBS Y/C YPbPr HV LR
EXT2/AV2 type SCART CVBS RGB LR Select input source when connected with external
equipment
CVBS LR
YPbPr LR
None
EXT3/AV3 type None Select input source when connected with external
equipment
CVBS
CVBS LR
CVBS Y/C LR
YPbPr
YPbPr LR
YPbPr HV LR
SIDE I/O Off/On Select SIDE I/O On/Off
S-VIDEO (Y/C) Off/On Select S-VIDEO (Y/C) On/Off
HDMI 2 Off/On Select HDMI 2 On/Off
HDMI 3 Off/On Select HDMI 3 On/Off
HDMI side Off/On Select HDMI side On/Off
HDMI CEC Viewport 21:9 Off/On Select HDMI CEC Viewport 21:9 On/Off
HDMI CEC OneUX seamless Off/On Select HDMI CEC OneUX seamless On/Off
Miscellaneous Region Europe Select Region/country
AP-PAL-Multi
China
Australia
Latam
Russia
Tuner type Select type of Tuner used
Hotel mode Off Hotel mode is Off
Option numbers Group 1 e.g. “00008.01793.15421.08192” The first line (group 1) indicates hardware options 1
to 4
Group 2 e.g. “44013.34315.00000.00000” The second line (group 2) indicates software options
5 to 8
Store Store after changing
Initialise NVM N.A.
Store Select Store in the SAM root menu after making any
changes
Operation hours display 0003 In case the display must be swapped for repair, you
can reset the “”Display operation hours” to “0”. So,
this one does keeps up the lifetime of the display
itself (mainly to compensate the degeneration
behaviour)
Software maintenance Software events Display Display information is for development purposes
Clear
Test reboot
Test cold reboot
Test application crash
Hardware events Display Display information is for development purposes
Clear
Test setting Digital info Centre frequency: 774605208
QAM modulation: None Display information is for development purposes
Symbol rate:
Original network ID: 0
Network ID: 0
Transport stream ID: 0
Service ID: 0
Hierarchical modulation: 0
Selected video PID: 0
Selected main audio PID: 0
Selected 2nd audio PID: 0
Install start frequency 000 Install start frequency from “0” MHz
Install end frequency 999 Install end frequency as “999” MHz
Default install frequency
Installation Digital only Select Digital only or Digital + Analogue before
installation
Digital + Analogue
Main Menu Sub-menu 1 Sub-menu 2 Sub-menu 3 Description