4.0 MECHANICAL INSTRUCTION
6. Remove 6pcs screws from key board.
7. Remove 6pcs of screws on the display frame. Carefully
open the display frame with the catches by
screwdriver.( There are six catches as shown in the
pictures)
Then you can see next picture.
8. To remove the TFT, de-soldering the wire connected
between TFT and TFT board first. (Please note the wire
location as shown in picture during re-assembly)
And up pulg wire connecter from TFT board and TFT driver.
Take out the TFT board from cabinet using eradicator.
9. To remove the hinge, remove the screws on the hinge.
To Next Page
Loading...
