EN 10
13. (Back): Return to the previous menu
page or exit from a TV function.
14. CH - / CH +: Switch channels.
15. +/-(Volume): Adjust volume.
16. (Mute): Mute or restore audio.
17. Colour buttons: Select tasks or options.
The buttons function according to the
services offered by the service provider.
18. SUBTITLE: Switch subtitles on or off.
19. 0-9 (Numeric buttons): Select TV
channels or enter text.
20. TEXT: Enable or disable text.
EasyLink controls
If you connect your TV to HDMI-CEC
enabled devices, such as a Blu-ray player or
home theatre, you can control them at the
same time with one remote control. Simply
switch on EasyLink after connection.
Watch TV
Switch TV on or off
Switch the TV on
Connect the TV to the mains outlet
and switch on the main power.
If the standby LED is lit, press on the
remote control.
Note: There is a short delay before the TV
responds.
Tip: If you cannot find your remote control
and want to switch on the TV from standby,
press on the TV.
Switch TV to standby
Press on the remote control.
The standby LED on the TV switches to red.
Switch off the TV
Press on the TV.
The standby LED switches to off.
Note: Though your TV consumes very little
energy when it is in standby or switched off,
it does use some energy. If you are not going
to use the TV for an extended period of
time, disconnect the TV from the mains plug.
Adjust TV volume
Increase or decrease the TV volume
Press +/- on the remote control.
Mute or restore the TV volume
Press on the remote control to
mute the volume.
Press again to restore the volume.
Adjust headphone volume
1. Press .
2. Select [Setup] > [TV settings] > [Sound]
> [Headphone volume], then press OK.
3. Select a level.
To Next Page
Loading...
