Philips Pocket Memo DPM8500 - Decode UPC;EAN Supplemental Redundancy

13Barcode scanner configuration guide
Parameter Menus 4 - 19
Decode UPC/EAN Supplementals (continued)
Enable 977 Supplemental Mode
(07h)
Enable 414/419/434/439 Supplemental Mode
(06h)
Enable 491 Supplemental Mode
(08h)
Enable Smart Supplemental Mode
(03h)
Decode UPC/EAN Supplemental Redundancy
Parameter # 50h
With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts the number of times a symbol without
supplementals are decoded before transmission. The range is from 2 to 20 times. Five or above is recommended when
decoding a mix of UPC/EAN symbols with and without supplementals, and the autodiscriminate option is selected.
Scan the bar code below to select a decode redundancy value. Next scan two numeric bar codes beginning on page 4-73.
Single digit numbers must have a leading zero. To change the selection or cancel an incorrect entry, scan Cancel on page
4-74.
Decode UPC/EAN Supplemental Redundancy
(Default: 7)
Decode UPC/EAN Supplemental Redundancy
Parameter # 50h
With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts the number of times a symbol without supplementals are decoded
before transmission. The range is from 2 to 20 times. Five or above is recommended when decoding a mix of UPC/EAN symbols with and without
supplementals, and the autodiscriminate option is selected. Scan the bar code below to select a decode redundancy value. Next scan two numeric bar
codes beginning on page 56. Single digit numbers must have a leading zero. To change the selection or cancel an incorrect entry, scan Cancel on page
57.
Parameter Menus 4 - 19
Decode UPC/EAN Supplementals (continued)
Enable 977 Supplemental Mode
(07h)
Enable 414/419/434/439 Supplemental Mode
(06h)
Enable 491 Supplemental Mode
(08h)
Enable Smart Supplemental Mode
(03h)
Decode UPC/EAN Supplemental Redundancy
Parameter # 50h
With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts the number of times a symbol without
supplementals are decoded before transmission. The range is from 2 to 20 times. Five or above is recommended when
decoding a mix of UPC/EAN symbols with and without supplementals, and the autodiscriminate option is selected.
Scan the bar code below to select a decode redundancy value. Next scan two numeric bar codes beginning on page 4-73.
Single digit numbers must have a leading zero. To change the selection or cancel an incorrect entry, scan Cancel on page
4-74.
Decode UPC/EAN Supplemental Redundancy
(Default: 7)