Philips Pocket Memo DPM8500 - UPC-E1 Preamble; Convert UPC-E to UPC-A; Convert UPC-E1 to UPC-A

18 Barcode scanner configuration guide
UPC-E1 Preamble
Parameter # 24h
Preamble characters (Country Code and System Character) can be transmitted as part of a UPC-E1 symbol. Select one of the following options for
transmitting UPC-E1 preamble to the host device: transmit system character only, transmit system character and country code (“0” for USA), or
transmit no preamble.
4 - 24 SE655 Decoded Linear Imaging Engine
UPC-E1 Preamble
Parameter # 24h
Preamble characters (Country Code and System Character) can be transmitted as part of a UPC-E1 symbol. Select one of
the following options for transmitting UPC-E1 preamble to the host device: transmit system character only, transmit system
character and country code (“0” for USA), or transmit no preamble.
No Preamble
(<DATA>)
(00h)
*System Character
(<SYSTEM CHARACTER> <DATA>)
(01h)
System Character & Country Code
(< COUNTRY CODE> <SYSTEM CHARACTER> <DATA>)
(02h)
Convert UPC-E to UPC-A
Parameter # 25h
Enable this parameter to convert UPC-E (zero suppressed) decoded data to UPC-A format before transmission. After conversion, data follows
UPC-A format and is aected by UPC-A programming selections (e.g., Preamble, Check Digit).
Scan DO NOT CONVERT UPC-E TO UPC-A to transmit UPC-E (zero suppressed) decoded data.
Parameter Menus 4 - 25
Convert UPC-E to UPC-A
Parameter # 25h
Enable this parameter to convert UPC-E (zero suppressed) decoded data to UPC-A format before transmission. After
conversion, data follows UPC-A format and is affected by UPC-A programming selections (e.g., Preamble, Check Digit).
Scan DO NOT CONVERT UPC-E TO UPC-A to transmit UPC-E (zero suppressed) decoded data.
Convert UPC-E to UPC-A (Enable)
(01h)
*Do Not Convert UPC-E to UPC-A (Disable)
(00h)
Convert UPC-E1 to UPC-A
Parameter # 26h
Enable this parameter to convert UPC-E1 (zero suppressed) decoded data to UPC-A format before transmission. After
conversion, data follows UPC-A format and is affected by UPC-A programming selections (e.g., Preamble, Check Digit).
Scan DO NOT CONVERT UPC-E TO UPC-A to transmit UPC-E1 (zero suppressed) decoded data.
Convert UPC-E1 to UPC-A (Enable)
(01h)
*Do Not Convert UPC-E1 to UPC-A (Disable)
(00h)