28 Barcode scanner configuration guide
ISBT Concatenation Redundancy
Parameter # DFh
If you set ISBT Concatenation to Autodiscriminate, use this parameter to set the number of times the digital scanner must decode an ISBT symbol
before determining that there is no additional symbol.
Scan the bar code below, then scan two numeric bar codes in Numeric Bar Codes on page 56 to set a value between 2 and 20. Enter a leading zero
for single digit numbers. To correct an error or change a selection, scan Cancel on page 57. The default is 10.
Parameter Menus 4 - 35
Check ISBT Table
Parameter # F1h 42h
The ISBT specification includes a table that lists several types of ISBT bar codes that are commonly used in pairs. If you
set ISBT Concatenation to Enable, enable Check ISBT Table to concatenate only those pairs found in this table. Other
types of ISBT codes are not concatenated.
*Enable Check ISBT Table
(01h)
Disable Check ISBT Table
(00h)
ISBT Concatenation Redundancy
Parameter # DFh
If you set ISBT Concatenation to Autodiscriminate, use this parameter to set the number of times the digital scanner
must decode an ISBT symbol before determining that there is no additional symbol.
Scan the bar code below, then scan two numeric bar codes in Numeric Bar Codes on page 4-73 to set a value between 2
and 20. Enter a leading zero for single digit numbers. To correct an error or change a selection, scan Cancel on page 4-74.
The default is 10.
To Next Page
Loading...
