Philips Pocket Memo DPM8500 - Code 39 Check Digit Verification; Transmit Code 39 Check Digit

32 Barcode scanner configuration guide
Code 39 Check Digit Verification
Parameter # 30h
When this feature is enabled, the scan engine checks the integrity of all Code 39 symbols to verify that the data complies with specified check digit
algorithm. Only those Code 39 symbols which include a modulo 43 check digit are decoded. Only enable this feature if your Code 39 symbols contain
a module 43 check digit.
Parameter Menus 4 - 39
Code 39 Check Digit Verification
Parameter # 30h
When this feature is enabled, the scan engine checks the integrity of all Code 39 symbols to verify that the data complies
with specified check digit algorithm. Only those Code 39 symbols which include a modulo 43 check digit are decoded. Only
enable this feature if your Code 39 symbols contain a module 43 check digit.
Verify Code 39 Check Digit
(01h)
*Do Not Verify Code 39 Check Digit
(00h)
Transmit Code 39 Check Digit
Parameter # 2Bh
Scan this symbol to transmit the check digit with the data.
Transmit Code 39 Check Digit (Enable)
(01h)
Scan this symbol to transmit data without the check digit.
*Do Not Transmit Code 39 Check Digit (Disable)
(00h)
Transmit Code 39 Check Digit
Parameter # 2Bh
Scan this symbol to transmit the check digit with the data.
Parameter Menus 4 - 39
Code 39 Check Digit Verification
Parameter # 30h
When this feature is enabled, the scan engine checks the integrity of all Code 39 symbols to verify that the data complies
with specified check digit algorithm. Only those Code 39 symbols which include a modulo 43 check digit are decoded. Only
enable this feature if your Code 39 symbols contain a module 43 check digit.
Verify Code 39 Check Digit
(01h)
*Do Not Verify Code 39 Check Digit
(00h)
Transmit Code 39 Check Digit
Parameter # 2Bh
Scan this symbol to transmit the check digit with the data.
Transmit Code 39 Check Digit (Enable)
(01h)
Scan this symbol to transmit data without the check digit.
*Do Not Transmit Code 39 Check Digit (Disable)
(00h)
Scan this symbol to transmit data without the check digit.
Parameter Menus 4 - 39
Code 39 Check Digit Verification
Parameter # 30h
When this feature is enabled, the scan engine checks the integrity of all Code 39 symbols to verify that the data complies
with specified check digit algorithm. Only those Code 39 symbols which include a modulo 43 check digit are decoded. Only
enable this feature if your Code 39 symbols contain a module 43 check digit.
Verify Code 39 Check Digit
(01h)
*Do Not Verify Code 39 Check Digit
(00h)
Transmit Code 39 Check Digit
Parameter # 2Bh
Scan this symbol to transmit the check digit with the data.
Transmit Code 39 Check Digit (Enable)
(01h)
Scan this symbol to transmit data without the check digit.
*Do Not Transmit Code 39 Check Digit (Disable)
(00h)