Set Lengths for Code 11
Parameter # L1 = 1Ch L2 = 1Dh
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s) the code
contains. Set lengths for Code 11 to any length, one or two discrete lengths, or lengths within a specific range.
•
One Discrete Length - Select this option to decode only Code 11 symbols containing a selected length. Select the
length using the numeric bar codes beginning on page 4-73. For example, to decode only Code 11 symbols with 14
characters, scan Code 11 - One Discrete Length, then scan 1 followed by 4. To correct an error or to change the
selection, scan Cancel on page 4-74.
•
Two Discrete Lengths - Select this option to decode only Code 11 symbols containing either of two selected
lengths. Select lengths using the numeric bar codes beginning on page 4-73. For example, to decode only those
Code 11 symbols containing either 2 or 14 characters, select Code 11 - Two Discrete Lengths, then scan 0, 2, 1,
and then 4. To correct an error or to change the selection, scan Cancel on page 4-74.
•
Length Within Range - Select this option to decode a Code 11 symbol with a specific length range. Select
lengths using numeric bar codes beginning on page 4-73. For example, to decode Code 11 symbols containing
between 4 and 12 characters, first scan Code 11 - Length Within Range. Then scan 0, 4, 1, and 2 (single digit
numbers must always be preceded by a leading zero). To correct an error or change the selection, scan Cancel
on page 4-74.
•
Any Length - Scan this option to decode Code 11 symbols containing any number of characters within the scan
engine capability.
To Next Page
Loading...
