55Barcode scanner configuration guide
Enable/Disable GS1 DataBar Expanded
Parameter # F0h 54h
To enable or disable GS1 DataBar Expanded, scan the appropriate bar code below.
4 - 66 SE655 Decoded Linear Imaging Engine
Enable/Disable GS1 DataBar Expanded
Parameter # F0h 54h
To enable or disable GS1 DataBar Expanded, scan the appropriate bar code below.
*Enable GS1 DataBar Expanded
(01h)
Disable GS1 DataBar Expanded
(00h)
Convert GS1 DataBar to UPC/EAN
Parameter # F0h 8Dh
This parameter only applies to GS1 DataBar Omnidirectional and GS1 DataBar Limited symbols. When this conversion is
enabled, GS1 DataBar Omnidirectional and GS1 DataBar Limited symbols encoding a single zero as the first digit have the
leading '010' stripped and the bar code reported as EAN-13.
Bar codes beginning with two or more zeros but not six zeros have the leading '0100' stripped and the bar code reported as
UPC-A. The UPC-A Preamble parameter to transmit the system character and country code applies to converted bar
codes. Note that neither the system character nor the check digit can be stripped.
Enable Convert GS1 DataBar to UPC/EAN
*Disable Convert GS1 DataBar to UPC/EAN
Convert GS1 DataBar to UPC/EAN
Parameter # F0h 8Dh
This parameter only applies to GS1 DataBar Omnidirectional and GS1 DataBar Limited symbols. When this conversion is enabled, GS1 DataBar
Omnidirectional and GS1 DataBar Limited symbols encoding a single zero as the first digit have the leading ‘010’ stripped and the bar code reported as
EAN-13.
Bar codes beginning with two or more zeros but not six zeros have the leading ‘0100’ stripped and the bar code reported as UPC-A. The UPC-A
Preamble parameter to transmit the system character and country code applies to converted bar codes. Note that neither the system character nor
the check digit can be stripped.
4 - 66 SE655 Decoded Linear Imaging Engine
Enable/Disable GS1 DataBar Expanded
Parameter # F0h 54h
To enable or disable GS1 DataBar Expanded, scan the appropriate bar code below.
*Enable GS1 DataBar Expanded
(01h)
Disable GS1 DataBar Expanded
(00h)
Convert GS1 DataBar to UPC/EAN
Parameter # F0h 8Dh
This parameter only applies to GS1 DataBar Omnidirectional and GS1 DataBar Limited symbols. When this conversion is
enabled, GS1 DataBar Omnidirectional and GS1 DataBar Limited symbols encoding a single zero as the first digit have the
leading '010' stripped and the bar code reported as EAN-13.
Bar codes beginning with two or more zeros but not six zeros have the leading '0100' stripped and the bar code reported as
UPC-A. The UPC-A Preamble parameter to transmit the system character and country code applies to converted bar
codes. Note that neither the system character nor the check digit can be stripped.
Enable Convert GS1 DataBar to UPC/EAN
*Disable Convert GS1 DataBar to UPC/EAN
To Next Page
Loading...
