Philips PT860 - Cleaning and Maintenance; Cleaning Shaving Unit Under Tap

Storage
- Put the protection cap on the shaver after use to prevent damage and
to avoid dirt accumulation in the shaving heads.
- PT866 only: Store the appliance and the accessories in the pouch.
Replacement
For maximum shaving performance, we advise you to replace the shaving
heads every two years. Replace damaged shaving heads right away.
Only replace the shaving heads with original HQ8 Philips Shaving Heads.
1 Switch off the shaver and disconnect it from the mains.
2 Press the release button to open the shaving unit.
3 Pull the shaving unit off the shaver.
4 Turn the lock anticlockwise (1) and remove the retaining frame (2).
5 Remove the shaving heads and place new ones in the shaving unit.
Note: Make sure the projections of the shaving heads t exactly into the
recesses.
6 Put the retaining frame back into the shaving unit and turn the lock
clockwise.
7 Insert the lug of the shaving unit into the slot in the top of the shaver
(1). Then close the shaving unit (2).
Note: If the shaving unit does not close smoothly, check if you have inserted
the shaving heads properly and if the retaining frame is locked.
ENGLISH 11