Philips PT920 - Cleaning Shaving Unit (Jet Clean); Preparing Jet Clean System

Cleaning the shaving unit in the Jet Clean
System (PT920CC only)
The Jet Clean System cleans the shaving unit.
Preparing the Jet Clean System for use
Note: Fill the cleaning chamber before rst use and
when the ‘uid low’ symbol ashes to indicate that the
uid level is too low. When the uid level drops below
the minimum level, the cleaning symbol and the ‘uid
low’ symbol start to ash and the shaver holder returns
to its starting position
1 Simultaneously press the release buttons
on both sides of the cleaning chamber (A).
Then lift the Jet Clean System off the cleaning
chamber (B).
, The cleaning chamber remains behind.
2 Unscrew the cap from the bottle with Jet
Clean solution (HQ200) and remove the
airtight seal.
3 Fill the cleaning chamber with Jet Clean
solution (HQ200) up to the MAX indication.
Note: Make sure the cleaning chamber is always lled
above the MIN indication.
4 Place the Jet Clean System back onto the
cleaning chamber (‘click’).
Make sure that the release buttons snap back into
place.
When the cleaning chamber is lled with Jet Clean
solution, do not move it to prevent leakage.
5 Put the small plug in the Jet Clean System and
put the adapter in the wall socket.
ENGLISH 17