Problem Possible cause Solution
You have not closed
the locking lever
of the Jet Clean
System properly,
or you have not
placed the shaver
in the Jet Clean
Shaver properly. In
these cases the Jet
Clean System starts
to operate, but the
cleaning program
is not performed
properly.
Place the shaver without
protection cap in the Jet
Clean System properly.
Close the locking lever
properly.
PT920CC: The
Jet Clean System
does not work
when I press the
on/off button.
The Jet Clean
System is not
connected to the
mains.
Put the small plug in the Jet
Clean System and put the
adapter in the wall socket.
Water leaks
from the shaver
after cleaning.
This is normal and
not dangerous.
During rinsing some water
may collect between the
power unit and the housing.
After rinsing this water ows
out through the socket. The
power unit is completely
watertight so water cannot
reach the electronic parts
of the shaver. Your shaver
continues to be absolutely
safe.
ENGLISH 27
To Next Page
Loading...
