Replacement
Only replace a damaged or worn cutting unit with an original Philips
cutting unit.
1 Push the middle part of the cutting unit upwards with your thumb
until it opens and then pull it off the appliance (Fig. 9).
2 Place the lug of the new cutting unit into the slot and push the
cutting unit onto the appliance (‘click’) (Fig. 10).
Environment
- Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an ofcial collection point for
recycling. By doing this, you help to preserve the
environment (Fig. 13).
- The built-in rechargeable battery contains substances that may
pollute the environment. Always remove the battery before you
discard and hand in the appliance at an ofcial collection point.
Dispose of the battery at an ofcial collection point for batteries. If
you have trouble removing the battery, you can also take the
appliance to a Philips service centre. The staff of this centre will
remove the battery for you and will dispose of it in an
environmentally safe way. (Fig. 14)
Removing the rechargeable battery
Only remove the rechargeable battery if it is completely empty.
1 Disconnect the appliance from the mains and let the appliance run
until the motor stops.
2 Push the middle part of the cutting unit upwards with your thumb
until it opens and then pull it off the appliance (Fig. 9).
3 Remove the upper housing part from the inner part of the
appliance with a screwdriver (Fig. 15).
4 Separate the lower housing part from the appliance (Fig. 16).
5 Remove the result indicator from the appliance (Fig. 17).
ENGLISH 11
To Next Page
Loading...
