5 Push out the inner body by pushing the
screwdriver into the bottom of the handle.
-
Now you see the printed circuit board.
6 QP6510: remove the cover of the printed circuit
board with the screwdriver.
7 Remove the printed circuit board from the inner
body with the screwdriver.
8 Lift the battery out of the inner body with the
screwdriver. The battery is connected with
double-sided tape.
Warning: Be careful, the battery strips are
very sharp.
Guarantee and support
If you need information or support, please visit
www.philips.com/support or read the separate
worldwide guarantee leaflet.
Guarantee restrictions
The blade is not covered by the terms of the
international guarantee because it is subject to
wear.
21
English
To Next Page