Philips QT4015 - Page 10

5 Shake off excess water and place the cutting
unit back by inserting the lug of the cutting unit
into the guiding slot.
6 Push the cutting unit back onto the appliance
(‘click’).
Replacement
Only replace a worn or damaged cutting unit with
an original Philips cutting unit, available from
authorised Philips service centres.
1 Open the cutting unit.
2 Remove the old cutting unit by pushing against
the teeth of the cutting unit.
3 Insert the lug of the new cutting unit into the
guiding slot.
4 Push the cutting unit back onto the appliance
(‘click’).
ENGLISH10