Cleaning
The appliance is fully washable.
Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the appliance.
1 Make sure the appliance is switched off and disconnected from the
mains.
2 Remove the beard trimming comb (Fig. 8).
Note: Never pull at the exible top of the beard trimming comb. Always pull at
the bottom part.
3 Open the cutting unit (Fig. 9).
4 Clean the inside and outside of the appliance under a running tap or
use the cleaning brush (Fig. 10).
5 Push the cutting unit back onto the appliance to close it
(‘click’) (Fig. 11).
Note: The appliance does not need any lubrication.
Replacement
Only replace a worn or damaged cutting unit with an original Philips cutting
unit, available from authorised Philips service centres.
1 Open the cutting unit (Fig. 9).
2 Pull the old cutting unit upwards to remove it (Fig. 12).
3 Insert the two lugs of the new cutting unit into the guiding
slots (Fig. 13).
4 Push the cutting unit back onto the appliance (‘click’) (Fig. 11).
Environment
Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an ofcial collection point for
recycling. By doing this, you help to preserve the environment (Fig. 14).
The built-in rechargeable battery contains substances that may pollute
the environment. Always remove the battery before you discard and
-
-
ENGLISH
To Next Page
Loading...
