Philips RC328 - Page 14

14
INITIALISATION (to modify the set's initial settings to your preferences)
m Selecting personal settings 7
Press the BND key for at least 2 seconds (until you hear a beep) to enter the ‘INIT’ mode.
The display shows ‘INIT’ and then the setting to be changed.
Press the —« or B> one or more times until the option you want to modify is displayed (see
list of INIT’ options).
Briefly press the AST key one or more times to adjust the choice.
— The choice shown on the display will be memorized by the set when you select another
option or leave the ‘INIT’ mode.
Press the BND key for at least 2 seconds (until you hear a beep) to leave the ‘INIT’ mode.
Note: The set automatically leaves the ‘INIT’ mode (with a beep) about 1 minute after your last operation.
‘INIT’ options
Initial settings (when set leaves factory) are shown in bold. If you are unsure of the best choice, choose
the factory setting.
- Select ‘CDC’ if connecting a Philips CD* changer (DB type).
SRC* [CDC, AUX]
- Select ‘AUX’ if connecting a portable audio player.
LOUD [HI, MID, LOW] Select desired volume level during LOUD ON.
[-2,-1,O, +1, +2] | Volume level of cassette relative to tuner.
[-2,-1,O,+1,+2] | Volume level of CD* Changer relative to tuner.
[-2,-1,O,+1,+2] | Volume level of AUX input relative to tuner.
[O, +1, +2, +3, +4] | Volume level of Traffic Announcements and News bulletins
relative to tuner
Select 'ON' if you want Alternate Frequency.
Select ‘OFF’ to suppress MW band if it is not used.
Select ‘OFF’ to suppress LW band if it is not used.
Select ‘OFF’ to suppress the SW band if it is not used.
Source connected to connector C of the car radio:
TUNER [EUROPE, USA ] Select desired AM Tuner range.
TIME [12H, 24H] Select desired clock format.
BLEEP [O, +1, +2, +3, +4] | Select volume level of confirmation beeps (useful if externa
amplifier is connected).
PHONE | [NO, LO, HI] Select ‘LO’ or ‘HI’ according to phone (‘LO’ in most cases).
Select ‘NO’ if no phone connected.
[PHIL, OPEL, FIAT] | Select desired types of wired remote control.
—
Note: (REF) Reference volume can be preset by using the volume up or down keys during the 'INIT' mode.
Select ‘ON’ if you want to be able to use the set even when the car
ignition is switched off. The ‘On/off logic’ feature enables use of the
set (for one hour) even when you have removed the car ignition key
(See ‘MOUNTING INSTRUCTIONS’.)
*only for certain versions.