62
• Key test
- Press each key to verify it is functioning correctly
• Display test
- Lights all LED lights
• Functions
- Sleep
Turns sleep mode on or o. When o, display power is always on.
- Pause
Turns pause mode on or o. When on, pause lasts 30 minutes.
- Odometer reset
Reset odometer readings
- Units
Set display to english or metric readings
- Grade return (GS Mode)
Turns GS mode on or o. Returns the elevation to lowest setting
when pause is pressed
- Beep
Turns the speaker (beep sound) on or o.
- Service mode:
Incline
- MW scrolls: “Use incline keys for front use speed keys for rear” then
switch to VR display below.
- Incline keys operate front motor, speed keys operate rear motor.
Hold down up/down key to operate motor, stop when key is released.
Motor is allowed to move until limit switch activated.
- MW displays A/D values for both position sensors. Example of the
readings F920 R 70. F=Front incline sensor and R = Rear incline
sensor. The readings will be opposite: when at lowest incline the front
will show a large number and rear will be small.
- Drive Motor
MW displays: “Use speed keys to move motor”. Each key press
increases motor speed 0.1 mph/kph
MW then shows: RPM 000 AMP 00.0. The sensor reading
indicates motor RPM, not belt speed. The AMP is measuring motor
current
1
2
To Next Page
Loading...