16
SimplyGo Mini User Manual
To set up the SimplyGo Mini device, follow these steps�
1� Connect a nasal cannula to the patient cannula connector on the
device, as shown� Ensure that the cannula is routed to prevent it from
being pinched or kinked to avoid a disruption of oxygen ow�
Note: A standard single lumen nasal cannula and tubing (not supplied)
should be used to deliver oxygen from the SimplyGo Mini device�
The device works with cannula tubing up to 10 ft� (3m)� The proper
placement and positioning of the nasal cannula in the nose is critical to
the consistent operation of the SimplyGo Mini�
2� Power on the device as described in the next section�
3� Position the nasal cannula on your face, as shown below, and breathe
normally through your nose�
To Next Page
Loading...
