Appendix A
A-6 Respironics V60 Ventilator User Manual 1047358 Rev N
First-time installation
Installing oxygen
inlet connector and
AC power cord
Respironics V60 Ventilators destined for Japan, China and the U.S. are pre-
configured. V60 Ventilators shipped to other countries may require installation
of the power cord and oxygen inlet connector.
1. Install the oxygen inlet connector as follows (Figure A-3):
a. Gently fit connector into the hole provided with flat sides to the
left and right.
b. Install the oxygen inlet connector retaining plate. Tighten the two
screws with a 2.5-mm hex wrench.
Figure A-3: Installing the oxygen inlet connector
Retaining plate
Oxygen
inlet
connector
To Next Page
Loading...
