Appendix A
First-time installation
1047358 Rev N Respironics V60 Ventilator User Manual A-7
WARNING: To prevent unintentional disconnection of the power cord, always use the
correct, Philips-supplied power cord and lock it into place with the power
cord retainer before you switch the ventilator on. The retainer is designed
to hold the connector end of the Philips-supplied cord securely in place.
WARNING: The V60 ventilator should not be positioned in a way that makes it
difficult to disconnect from mains power if necessary. Disconnect from
supply mains by removing the power cord from the wall outlet.
2. Secure the power cord with the power cord retainer (Figure A-4):
a. Remove the power cord retainer by removing two screws.
b. Connect the power cord that is appropriate to your region into the
AC power connector.
c. Reinstall the power cord retainer over the power cord, and tighten
the screws with a 3.0-mm hex wrench.
Figure A-4: Installing the power cord retainer
To Next Page
Loading...
