EasyManua.ls Logo

Philips Respironics V60 - 3.2.1 Power management (PM) PCBA; 3.2.2 Power Supply; 3.2.3 Internal Battery

Philips Respironics V60
194 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 3
General information
1047358 Rev N Respironics V60 Ventilator User Manual 3-5
Table 3-1: Recommended parts and accessories
Part Use...
Patient circuit Single-limb patient circuit intended for
noninvasive or invasive ventilation. To
minimize turbulence, we recommend that
you use smooth-bore tubing. Use a circuit
listed in Appendix C.
WARNING:
During ventilation, patient exhalate is
released into room air. Use of a patient
circuit with a filter on its exhalation port is
recommended.
Patient interface (noninvasive or invasive) Respironics masks listed in Appendix C
Invasive interface (tracheostomy or ET
tube)
Exhalation port Philips Respironics exhalation port listed in
Appendix C. Contact your Philips
representative.
Inspiratory filter Main flow (inspiratory) bacteria filter listed
in Appendix C
Humidifier Fisher & Paykel
MR810 or MR850
Fisher & Paykel
MR290 chamber
Oxygen monitor Teledyne MX300 oxygen monitor
An equivalent that complies with
ISO 7767
Nebulizer Vibrating mesh nebulizer, such as the
Aerogen
Jet nebulizer with low drive flow
requirements (< 10 L/min)

Table of Contents

Other manuals for Philips Respironics V60

Related product manuals