Chapter 7
Component Removal/Installation
1049766 Rev A V60 Ventilator Service Manual 7-41
7.37 Bottom Feet Follow these steps to remove the bottom feet (section Figure 7-38:). Reverse
to install.
CAUTION: Follow these instructions to remove the right rear bottom foot: it is
attached with a hex nut inside the base assembly.
1. Remove the 3 screws that attach the front and left rear bottom feet to
the base assembly.
2. Disconnect all power (section 7.1).
3. Remove the GDS (section 7.20).
4. From inside the base assembly, remove the hex nut that attaches the
screw and bottom foot.
Figure 7-38: Removing the Bottom Feet
M4 hex kep nut (x1)
(113 +
11.3 N cm/
10 +
1 in.-lbf)
M4 x 14 screw (x4)
(113 +
11.3 N cm/
10 +
1 in.-lbf)
To Next Page
Loading...
