Philips Respironics V60 - 8.4.1 Measurement Selection Screen

Chapter 8
8-10 V60 Ventilator Service Manual 1049766 Rev A
Performance Verification
• Low Pressure (cmH
2
O)
• Absolute Pressure (mmHg)
• Flow Rate (SLPM)
• Oxygen Concentration (%)
• Peak Pressure (cmH
2
O)
• PEEP Pressure (cmH
2
O)
3. To select or change the measured gas, touch the gas dropdown list and
select the gas.
4. Touch OK when parameters selection and order is complete.
8.4.2 Averaging Setup Menu
Use the Averaging Setup Menu to select averages for breath parameters (how
many breaths are averaged) and real-time transducer values (the time interval
used for averaging).
1. Touch the Breath Average button to display the Averaging Setup Menu
(Figure 8-3).
Figure 8-3: Averaging Setup Menu (Certifier FA Plus)
Breath Average button
Second Average for
Real-Time Values = 2.0
Number of Breaths
Averaged = 5