Chapter 5
Diagnostic Mode and Troubleshooting
1049766 Rev A V60 Ventilator Service Manual 5-7
5.1.4 Selecting Pressure Units
The Set Pressure Units screen allows you to select what unit of pressure the
ventilator displays during ventilation and Diagnostic modes.
1. From the System Settings screen, touch Pressure Units.
2. Touch the selected pressure unit button on the Set Pressure Units
screen (Figure 5-7).
Figure 5-7: Set Pressure Units Screen
3. The screen displays the selected pressure unit and this message:
Pressure units will apply after a ventilator shutdown and restart.
4. To apply the new unit of pressure, touch Ventilator Shutdown.
To exit without changing the unit of pressure, touch Cancel.
To Next Page
Loading...
