Philips S5898 - Quick Clean Pod Operation; Pod Setup and Sealing

18
English
3
Lift the tab on the seal and pull it by the corner to
remove the seal from the Quick Clean Pod Cartridge.
4
Press the small circular piece on the handle of the
Quick Clean Pod Cartridge to break the snap hook on
the handle.
5
Place the Quick Clean Pod Cartridge into the Quick
Clean Pod.
6
Put the top of the Quick Clean Pod back onto the base
and turn it clockwise until you hear a click.
Do not tilt the Quick Clean Pod to prevent leakage.
Using the Quick Clean Pod (specific models only)
Note: If you use the shaver with shaving foam, shaving
gel or pre-shave products, thoroughly rinse the shaving
heads before you use the Quick Clean Pod (see 'How do I
clean my appliance and the attachments?').