Philips S9711/23 - Beard Styler Attachment; Beard Styler with Comb

Using the beard styler attachment
1 Make sure the appliance is switched off.
2 Pull the shaving unit straight off the appliance.
Note: Do not twist the shaving unit while you pull it off
the appliance.
3
Insert the lug of the beard styler
attachment into the slot in the top of the
appliance. Then press down the beard styler
attachment to attach it to the appliance (‘click’).
Using the beard styler attachment with comb
You can use the beard styler attachment with the
comb attached to style your beard at one xed
setting, but also at different length settings. The
hair length settings on the beard styler attachment
correspond to the remaining hair length after cutting
and range from 1 to 5mm.
1 Slide the comb straight into the guiding
grooves on both sides of the beard styler
attachment (‘click’).
2 Press the length selector and then push it
to the left or right to select the desired hair
length setting.
3 Press the on/off button once to switch on the
appliance.
4 You can now start styling your beard.
ENGLISH 23