Before using
1 Be aware!
This appliance is not suitable for everyone. This Quick Start Guide does
not substitute the user manual. To ensure that Philips Lumea Prestige hair
removal system is suitable for you and safe for you to use, read the user
manual carefully before rst use.
Before you use Philips Lumea Prestige, perform a skin test:
Chooseahair-freeareaclosetotheareatobetreated.Applyoneash
(see steps 3-7 in chapter ‘Using’) at the lowest recommended intensity for
your skin colour. Increase the setting by one level within the recommended
range of settings. After the skin test, wait for 24 hours and check your skin
for any reactions. If you notice any skin reactions, choose the highest setting
that did not result in any skin reactions for subsequent use.
2 Recommended light intensities table
Consult the table on the following page to determine which light intensities
are most suitable for your skin and body hair colour and check if this
method is suitable for you.
The method is more effective at higher intensities; however, you should
reduce the light intensity if you experience any pain or discomfort. The light
pulse can feel warm or hot on the skin but should never be painful.
3 Check section ‘Contraindications’ in the user manual.
Some medications and health conditions might cause
adverse reactions when you use the appliance.
Note: All types of tanning may inuence the safety of the treatment. Wait at
least 48 hours after sunbathing before you use the appliance. Do not use
Philips Lumea Prestige on sunburnt body areas. See section ‘Tanning advice’
in the user manual for more information.
Recommended light intensities (1-5) (Fig. 5)
- In the table, ‘x’ means that the appliance is not suitable for you.
Preparing for use
1 Charge the appliance.
2 Shave the areas you intend to treat.
48
hr.
ENGLISH 7
To Next Page
Loading...
Need help?
General