Philips SC2009 - Treatment Application and Modes

5 Place the appliance at a 90° angle on the skin so that the attachment
and the safety ring are in contact with the skin.
6 Press the safety ring fully onto the skin with slight pressure.
When all contact switches of the appliance are in contact with the
skin, the ‘ready to ash’ light on the back of the appliance lights up
green.
7 Press the ash button to release a ash. Now you have 2 options to
release the next ash:
A Keeptheashbuttonpressed.Theappliancereleasesoneash
after another as long as the safety ring is in full contact with the skin.
Immediatelyaftertheappliancehasashed,slidetheappliancetothe
next area. Make sure the safety ring is fully pressed onto the skin.
This ‘Slide & Flash mode’ is especially convenient for treatment of larger
areas like the legs.
B Letgooftheashbuttonaftereachash.Forthenextash,placethe
applianceonthearearightnexttothepreviouslyashedarea.
Make sure the safety ring is fully pressed onto the skin.
This ‘Step & Flash mode’ guarantees a precise treatment of e.g. the upper
lip, knees or ankles.
Note: After a few seconds, the appliance is ready to ash again, so make sure
that you move it to the next area immediately after it has ashed.
Do not treat exactly the same area multiple times during one session.
This does not improve the effectiveness of the treatment, but increases
the risk of skin reactions.
8 To avoid untreated areas, always make sure there is some overlap
with the previously treated area when you place the appliance on the
skin.
9 Switch off the appliance after you have nished the treatment.
10 If there is any dirt on the attachment and/or the light exit window,
clean it before you store the appliance in the case. If necessary,
moisten the supplied cloth with water or high percentage alcohol for
cleaning. See chapter ‘Cleaning and maintenance’ in the user manual
for more information.
90°
ENGLISH 9