Philips Signage Solutions BDL5588XC - Unpacking and Installation; Unpacking and Package Contents; Installation Notes and Table Stands

BDL5588XC/55BDL3005X
1
1. Unpacking and Installation
1.1. Unpacking
• This product is packed in a carton, together with the standard accessories.
• Any other optional accessories will be packed separately.
• Due to the size and weight of this display it is recommended for two people to move it.
• After opening the carton, ensure that the contents are complete and in good condition.
1.2. Package Contents
Please verify that you received the following items with your package content:
• LCD display
• Remote control with AAA batteries
• Power cord
• DVI cable
• RS232 cable
• Daisy chain cable
• IR sensor cable
• IR cable
• Quick start guide
• Edge Alignment Kit-1: 1PC
• Edge Alignment Kit-2: 2PCS
• Thumb Screw: 8PCS
• Edge Alignment Pin: 2PCS
* The supplied power cord varies depending on destination.
Power Cord
DVI Cable
Quick start guide
Remote Control
and AAA Batteries
RS232 Cable
Daisy chain cable
Edge Alignment Kit-1
Edge Alignment Kit-2
Edge Alignment Pin
Thumb Screw
IR Sensor Cable
IR Cable
* Differences according to regions
Display design and accessories may differ from those illustrated above.
NOTES:
• For all other regions, apply a power cord that conforms to the AC voltage of the power socket and has been approved by and complies with the
safety regulations of the particular country.
• You might like to save the package box and packing material for shipping the display.
1.3. Installation Notes
• Due to the high power consumption, always use the plug exclusively designed for this product. If an extended line is required, please consult your
service agent.
• The product should be installed on a at surface to avoid tipping. The distance between the back of the product and the wall should be maintained
for proper ventilation. Avoid installing the product in the kitchen, bathroom or any other places with high humidity so as not to shorten the service life
of the electronic components.
• The product can normally operate only under 3000m in altitude. In installations at altitudes above 3000m, some abnormalities may be experienced.