7
Nightly Use
1. Wash your face and the area behind your right ear with mild soap and water. Dry
completely.
2. Visually inspect the headband prior to use for any damage.
3. Remove a SmartSleep Sensor from its pouch. Reseal the pouch to keep the
remaining sensors from drying out.
Note
The gel in the middle of the SmartSleep Sensor is very important to its function.
If the gel comes dislodged, discard the sensor and start again with a new one.
4. Move your hair away from the area behind your right ear. There should be no hair
between your skin and the sensor.
5. Place the SmartSleep Sensor on the bone behind your right ear.
Comfort tip
Place the sensor close to the hairline.
6. Place the SmartSleep headband on your head so that the forehead sensor is straight
across your forehead.
7. If you have long hair, pull the SmartSleep headband over your head until it is around
your neck and under your hair. Then, pull it up onto your head like a headband. This
helps move your hair away from behind your ear.
To Next Page
Loading...
