Problem Possible cause Solution
EN Water drips from the
Soleplate after the iron
has cooled down or
has been stored.
You have put the iron in
horizontal position with
water still left in the
water tank.
Empty the water tank.
Flakes and impurities
come out of the
soleplate during ironing.
inside the soleplate.
Use the Calc-Clean function one or
more times (see
).
When set to the max
position, the steam
You have not retained
the steam control in the
maximum position.
If you want to generate the
maximum steam rate, you have
to continuously hold the steam
control in the maximum position.
Please note, in other steam control
positions it is not necessary to
continuously hold the steam control.
BG
-
).
).
).
-
-
2
-
-
-
-
-
4239_000_8563_2_Picture Rich_A6_v1.indd 15 19/05/14 10:01
To Next Page
Loading...
