Philips sonicare 3000 Series - Using Your Cordless Power Flosser; Initial Setup and Water Spray; Flossing Technique

16
English
2
1
To remove the nozzle, press the nozzle release
button and pull the nozzle from the handle.
Using your Cordless Power Flosser
1 Before turning on the device, point the nozzle
tip at the sink. Press the on/off button on the
handle to turn on the Cordless Power Flosser.
Allow water to spray into the sink. Turn off the
device once water dispenses from the device.
2 Place the nozzle tip in your mouth. Lean over
the sink and partially close your lips over the
nozzle tip to avoid splashing. Leave enough
space to allow water to flow from your mouth
into the sink.
3 Press the on/off button on the handle to turn
on the Cordless Power Flosser.
4 With the Cordless Power Flosser turned on:
Note: Do not press nozzle release button while
using.
90°
a Position the nozzle tip just above the gum
line at a 90° angle.
Note: For the Quad Stream nozzle press gently
so that the nozzle tip is in contact with the
gum line and the teeth.