Philips Sonicare ProtectiveClean 5100 - Feature Activation and Deactivation; EasyStart Settings; Brush Head Reminder Settings

-
Brush head replacement reminder
-
Pressure sensor
To activate or deactivate these features, follow
the instructions below:
EasyStart
1 Put the handle on the plugged-in charger.
2 Press and hold the power on/off button
while the handle remains on the charger.
3 Keep the power on/off button pressed until
you hear a single short beep (after 2
seconds).
4 Release the power on/off button.
-
Triple tone of low-med-high means the
EasyStart feature has been activated.
The brush head replacement light and
battery light will also blink green 3 times
in unison to confirm activation.
-
Triple tone of high-med-low means the
EasyStart feature has been deactivated.
The brush head replacement light and
battery light will also blink amber 3 times
in unison to confirm deactivation.
Note: To achieve clinical efficacy, EasyStart
needs to be deactivated.
Brush head replacement reminder
1 Put the handle on the plugged-in charger.
2 Press and hold the power on/off button
while the handle remains on the charger.
16
English