EasyManua.ls Logo

Philips Sonicare ProtectiveClean 6100 - Cleaning and Maintenance; Cleaning the Toothbrush Handle; Cleaning the Brush Head; Cleaning the Charger

Philips Sonicare ProtectiveClean 6100
836 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
21
English
Battery status Battery indicator Sound
Empty Flashes amber The handle emits 2 sets
of 5 beeps after
brushing
Note: To save energy, the battery indicator will switch off
when not in use.
Note: When the battery is completely empty, the
toothbrush switches off. Place the toothbrush on the
charger or in the charging travel case to charge it.
Note: To keep the battery fully charged at all times, you
may keep your toothbrush on the charger when not in
use.
Cleaning
Toothbrush handle
1
Remove the brush head and rinse the metal shaft area
with warm water. Make sure you remove any residual
toothpaste.
Caution: Do not push on the rubber seal on the metal
shaft with sharp objects, as this may cause damage.
2
Wipe the entire surface of the handle with a damp
cloth.
Note: Do not tap the handle on the sink to remove excess
water.
Brush head
1
Rinse the brush head and bristles after each use.
2
Remove the brush head from the handle and rinse the
brush head connection with warm water at least once
a week. Rinse the travel cap as often as needed.
Charger
1
Unplug the charger before you clean it.
2
Wipe the surface of the charger with a damp cloth.

Table of Contents

Other manuals for Philips Sonicare ProtectiveClean 6100

Related product manuals