Instructions for use
English
5
Manually setting the remote control
1 Turn on the TV manually or use the original remote control.Tune in to channel 1.
2 Look up the brand of your TV in the code list at
the back of this manual. One or more four-figure codes are
shown for each brand. Note the first code.
On our website www.philips.com/urc you can directly select your
device typenumber to find the right code.
3 Use a pen or paper clip to press the Setup key and
keep it pressed for 5 seconds until the Standby key blinks
twice and then remains lit.
4 Then enter the code noted in step 2, using the digit keys.
– The Standby key will now blink twice. If the key blinks once
for an extended period, the code has not been entered
properly or the wrong code has been entered.
Start again from step 2.
5 Point the SRU 4010 at the TV and check that it responds as it should.
– If the TV responds to all of the key commands, the SRU 4010 is ready for use.
Do not forget to note your code.
• If the device does not respond at all, or not to all of the key commands, start
again from step 2 and try the next code from the list.
Automatically setting the remote control
The remote control will now automatically search for the right code for your device.
1 Make sure the TV is switched on and select a channel using the original remote
control or the keys on the TV (for example channel 1).
2 Use a pen or paper clip to press the Setup key and
keep it pressed for 5 seconds until the Standby key blinks
twice and then remains lit.
3 Press the Standby key of the SRU 4010 and
keep it pressed.
– The SRU 4010 now starts emitting all known ‘TV off’
signals, one by one. Each time a code is sent, the Standby
key lights up.
To Next Page
Loading...
Need help?
General
