Mechanical Instructions
EN 10 LCD AUO 2k74.
4.4 Model T296XW01V0 and T296XW01V3
4.4.1 Control Board
Disassembly
1. Place the panel face down on the foam bars, and locate the
Control board.
Figure 4-17 Control board location
2. Remove the four screws of the metal cover: start with the
right-down one, then the left-up, one, then the right-up one
and finally the left-down one.
Figure 4-18 Cover screws removal
3. Lift the cover from the Control board.
Figure 4-19 Lift cover
4. Carefully disconnect the flat cable/FPCs from their
connectors.
Figure 4-20 Unplug flat cable
Figure 4-21 Unplug FPCs
5. You can now remove the Control Board.
Reassembly
To reassemble, perform all processes in reverse order.
Important: Be sure to insert the FPCs correctly: the (white) line
must be invisible when inserted correctly (see figure below).
Figure 4-22 Correct FPC insertion
H_16900_002.eps
110707
H_16900_003.eps
110707
H_16900_004.eps
110707
H_16900_021.eps
110707
H_16900_020.eps
110707
H_16900_007.eps
110707
To Next Page
Loading...
