Mechanical Instructions
EN 8 LCD AUO 2k74.
4.3 Model T260XW03V1
4.3.1 Control Board
Disassembly
1. Place the panel face down on the foam bars, and locate the
Control board.
2. Remove the four screws of the metal cover: start with the
right-down one, then the left-up, one, then the right-up one
and finally the left-down one.
Figure 4-12 Cover screws removal
3. Lift the cover from the Control board.
4. Carefully disconnect the flat cable/FPCs from their
connectors.
Figure 4-13 Unplug FPCs
5. You can now remove the Control Board.
Reassembly
To reassemble, perform all processes in reverse order.
Important: Be sure to insert the FPCs correctly: the (white) line
must be invisible when inserted correctly (see figure below).
Figure 4-14 Correct FPC insertion
I_17791_037.eps
240808
I_17791_038.eps
240808
H_16900_007.eps
110707
To Next Page
Loading...
