MAINTENANCE :
2
02.9663.0010 F 14-May-2009 37
Step 4. At Controller PCB, disconnect shutter wiring harness at position marked
SHUTTERS.
Step 5. Noting placement, cut tie-wraps securing harness to other wires.
Step 6. Feed shutter harness cable out of yoke arm.
Step 7. At side rails, remove four 10-32x3/8" PPB screws and #10 split-lock washers
and remove shutter assembly (Figure 2-15).
CAUTION: Do not overtighten tie-wraps when re-installing.
Step 8. Replace shutter assembly by doing steps 2 through 7 in reverse.
Figure 2-15: Shutter Assembly Replacement
Head Assembly
Shutter Assembly
10-32x3/8" PPB Screw
#10 Split-Lock Washers
Yoke not shown for clarity.
NOTE:
Gobo Wheel Bulkhead
Side Rail Spacer
10-32x5/8" PPB Screw
#10 Split Lock Washer
Rear Head Assembly
OR
OLD *
NEW *
* Depending on when the luminaire was manufactured.
To Next Page
Loading...
