VARI❋LITE® - VL1000™ ERS LUMINAIRE SERVICE MANUAL
40 14-May-2009 02.9663.0010 F
Edge/Zoom/Color Bulkhead Replacement
Parts:
ASSEMBLY, EDGE CONTROL, DIMMER AND COLOR (21.9663.1003)
Tools:
#2 Phillips screwdriver
To remove and replace edge/zoom/color bulkhead:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove front cover. (Refer to “Front Cover Removal” on page 26.)
Step 3. At edge/zoom/color assembly, disconnect wiring harness connections.
Step 4. At side rail, remove four 8-32x1/2" PFB screws (Figure 2-18).
Step 5. At front, remove four 8-32 Keps nuts and remove assembly.
Step 6. Replace assembly by doing steps 2 through 5 in reverse.
Figure 2-18: Edge/Zoom/Color Bulkhead Replacement
8-32x1/2" PFB Screw
8-32 Keps Nut
Side Rail
Edge/Zoom/Color
Assembly
Yoke not shown for clarity.
NOTE:
To Next Page
Loading...
