MAINTENANCE :
2
02.9663.0010 F 14-May-2009 41
Fan/Temp Switch Assembly Replacement
Note: Fan does not operate under normal luminaire operating conditions.
Parts:
CABLE ASSEMBLY, FAN/TEMP SWITCH (23.9663.2009)
Tools:
#2 Phillips screwdriver
To remove and replace fan/temp switch assembly:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove edge/dimmer/color bulkhead. Refer to “Edge/Zoom/Color Bulkhead
Replacement” on page 40.
Step 3. At fan, remove four 6-32 x 3/8 " PPSS black screws and 6-32 nylon insert
hex nuts and remove fan/temp switch assembly (Figure 2-19).
Step 4. Replace assembly by doing steps 2 and 3 in reverse.
Figure 2-19: Fan/Temp Switch Assembly Replacement
6-32x3/8" PPSS Screw
6-32 Nylon Insert Hex Nut
To Next Page
Loading...
