38 EN
From now on, the device’s On/Off is controlled by the
POWER button as follows:
Switch off: When in the power-on state, slide the POWER
button until the “PHILIPS” picture is displayed, and then the
device is switched off.
Switch on: When in the power-off state, slide the POWER
button until the startup logo “PHILIPS” picture is displayed.
Note
•
•
If the device cannot work normally, please make sure the
device is not out of power.
When the battery indicator “ ” is displayed, please
charge the device promptly.
WAV 96K/24
00:00:00
00:10:06
REC056.WAV
4608kbps
A
4 Get started
4.1 Power On/Off
1 Slide the Power/Hold switch on the side of the device
downwards for approximately two seconds.
Note
•
The device turns on and the start-up screen is displayed.
Then the device displays the stopped playback
interface
Recharge the device for three hours before using it for
the first time!
To Next Page
Loading...
