EasyManua.ls Logo

Philips Voice Tracer VTR8800 - Recharge; Enabling;Disabling the Keypad Lock; Connecting to a Computer

Philips Voice Tracer VTR8800
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
38 EN
EN 39
English
Lock symbol will appear on the screen for a moment,
as shown in the picture below.
4.3 Key lock (Hold function)
4.4 Connecting to a computer
Push power on-off switch to “HOLD” to lock voice
recorder, and all the buttons on the device will be invalid.
1
2
Push power on-off switch to the opposite side to unlock
voice recorder.
The device can be used as a USB mass storage to
conveniently store, back up and move files. Link the device
to a computer with a USB cable. The voice recorder can
automatically be recognized as a mass storage device without
the need to install any software.
Note
•
While the device is connected to a computer, it cannot
be operated manually.
4.2 Recharge
There are two ways to recharge:
Directly connect the device with PC or through USB cable.
Use the specified charger to charge the device.
When using the above methods to recharge, the device will
be in the state of recharging. The battery indicator shows a
battery icon turning from empty to full repeatedly, indicating
that the device is recharging. Under normal circumstance,
the device can be fully recharged in around 3 hours. When
the device is fully recharged, the battery icon is full and the
orange indicator light turns off.
•
•

Related product manuals