Philips WelcomeEye Comfort DES9500VDP - Product Installation; Wiring; Configuring the Intercom

GB5
WelcomeEye Comfort / Compact / 08/17
5. PRODUCT INSTALLATION
Important notes and advice:
- To make the most of your intercom panel, we recommend conguring it (for 1 or 2
families, 1 or 2 intercoms, loudspeaker volume) before nal installation. To do this, a table
connection may be necessary to check that the settings are correct.
- If you test your product before installing it, ensure that you do not test it with the intercom
panel and the monitor in the same room to avoid the videophone emitting a shrill noise
(feedback).
- Do not expose the camera lens to direct sunlight or a reective surface.
- We recommend running the cables through a protective sheath to protect them against
breakage and bad weather.
1. Wiring.
To avoid the risk of interference and malfunctions, do not run the videophone cable through
the same sheath as the electrical cables.
Warning: Do not double up the wires to increase their section.
a. Connecting the videophone (monitor, intercom panel and camera, see g. 1, g. 2 and g. 3)
Wires to be used: 2 wires 0.75 mm
2
with 80 m length or 2 wires 1.5 mm
2
with 120 m length.
- Make sure to connect the wires in accordance with one of the wiring diagrams depending
on the desired conguration.
- Refer to the label stuck to the back of the monitor and the back of the intercom panel.
- Congure the switches on the back of the intercom panel as well as the monitor interface
according to the chosen conguration (see section 2 intercom conguration).
b. Connecting a gate motor
The camera delivers a dry contact with no current, to be connected to the push button
control of your automatic opener.
- Connect it directly to terminals 5 and 6 at the back of the intercom panel (no need to
observe polarity).
- The opening function is only possible if the video of the respective intercom panel is
displayed.
c. Connecting a strike plate or electric lock
Important: The strike plate or electric lock that you are ordering must have a mechanical
memory. The strike plate current cannot exceed 1.1A.
- Connect it directly to terminals 7 and 8 at the back of the intercom panel (no need to
observe polarity).
- The opening function is only possible if the video of the respective intercom panel is
displayed.
2. Conguring the intercom (see g. 1, g. 2 and g. 3)
a. Conguring the intercom number:
Place switch 2 on the left on intercom no. 1 and on the right on intercom no. 2.