Philips WelcomeEye Comfort - Installing a Camera (Optional); Monitor Interface Overview; Main Menu Navigation

GB8
WelcomeEye Comfort / Compact / 09/17
5 - Drill.
6 - Use the correct xings for the mounting surface (the screws provided are suitable for
solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike
plate and the gate (see section 1. Wiring). Congure the switches at the back of the
intercom panel (see section 2. Conguring the intercom).
8 – Insert the screws and ret the two caps concealing the retaining screws.
Note: the screws must be driven through the black grommets on the back of the outdoor
station.
9 – Ret the front cover of the intercom and tighten the tamper-resistant retaining screw.
10 - Connect the 230V AC power supply to the modular adaptor, for an installation compliant
with applicable standards (NFC 15-100 in France).
- Verify the smooth functioning (video call, etc.).
- When there is a second intercom panel, don’t forget to congure the monitor(s).
On
11 - Attach a silicone seal* between the shield and the wall to stop owing water. *Do
not use acetic acid-based silicone (vinegar odour).
5. Installing a camera (optional)
Connect the wires in accordance with the wiring diagram.
Choose a suitable place to install the camera.
Ensure that nothing gets in the way of the installation.
Screw the wall section with the screws provided (for solid walls).
Point the camera in the desired direction and tighten the retainer screw.
Congure the monitor(s)
On
Warning: no audio
6. MONITOR INTERFACE
Main Menu
Press the button to turn on the screen and access the main menu
00:00 01/01/2000
A B C
A. Monitoring function and response to a call
B. Intercom function
C. Settings