Philips WelcomeEye Connect 2 - Optional Camera Installation; MONITOR INTERFACE; Main Menu and Navigation; Monitoring and Call Response

F9
WelcomeEye Connect 2 / Touch / V4
5 - Drill.
6 - Use pegs adapted to the nature of the support (the screws supplied are suitable for
solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike
plate and the gate (see section 1. Wiring). Congure the switches at the back of the
intercom panel (see section 2. Conguring the intercom).
8 – Insert the screws and ret the two caps concealing the retaining screws.
Note: screw through the black covers on the back of the intercom panel without removing
them.
9 – Ret the front cover of the intercom and tighten the tamper-resistant retaining screw.
10 - Connect the 230V AC power supply to the modular adaptor, for an installation compliant
with applicable standards (NFC 15-100 in France).
- Verify the smooth functioning (video call, RFID, etc.).
- When there is a second intercom panel, don’t forget to congure the monitor(s).
On
11 - apply a silicone seal around the intercom panel to prevent any penetration of water.
5. Installing a camera (optional)
Connect the wires in accordance with the wiring diagram.
Choose a suitable place to install the camera.
Ensure that nothing gets in the way of the installation.
Screw the wall section with the screws provided (for solid walls).
Point the camera in the desired direction and tighten the retainer screw.
Congure the monitor(s)
On
6. MONITOR INTERFACE
Main menu
Lightly touch the screen to turn it on and access the main menu
23:59 01/07/2017
FULL
MEM.
22
4
23:59 01/07/2017
FULL
MEM.
A B C D E
A. Monitoring function
B. Intercom function
C. Settings
D. Photo album
E. Video album